Kiln Controller Troubleshooting
Click on error codes below to see the description, probable cause & possible correction step(s).
Kiln Support
Error Codes
The error codes are displayed as an “E” followed by a “-” then a number or letter. For example “E-1” stands for error one.
NOTE: If you get an error code it is important to note the error letter or number. It will help in diagnosing any problem with the kiln.
The list of error codes follows:
THESE ERRORS WILL ONLY BE DETECTED IF ERROR CODES (ERCD) ARE ON:
| Error Codes* | ||
|---|---|---|
| E-1 | E-2 | E-3 |
| E-4 | E-5 | E-d |
THE ERROR CODE SETTING DOES NOT AFFECT THESE ERRORS:
| Error Codes* | ||
|---|---|---|
| E-0 | E-6 | E-8 |
| E-9 | E-22 or E-26 | E-- |
| E-A | E-bd | E-E |
| E-R | E-U | ERRP |
| FAIL | STUC | P-F |
* Click on the code to view the description, probable causes and potential correction(s)
Description
Probable Causes and/or Correction(s)
Description
Probable Causes and/or Correction(s)
Description
Probable Causes and/or Correction(s)
Description
Probable Causes and/or Correction(s)
Description
Probable Causes and/or Correction(s)
Description
Probable Causes and/or Correction(s)
Description
Probable Causes and/or Correction(s)
Description
Probable Causes and/or Correction(s)
Description
Probable Causes and/or Correction(s)
Description
Probable Causes and/or Correction(s)
Description
Probable Causes and/or Correction(s)
Description
Probable Causes and/or Correction(s)
Description
Probable Causes and/or Correction(s)
Description
Probable Causes and/or Correction(s)
Description
Probable Causes and/or Correction(s)
Description
Probable Causes and/or Correction(s)
Description
Probable Causes and/or Correction(s)
Description
Probable Causes and/or Correction(s)
Description
Probable Causes and/or Correction(s)
Description
Probable Causes and/or Correction(s)
Description
Probable Causes and/or Correction(s)
Playlists
Below are playlists with helpful tutorials to help you use your Bartlett kiln controller.
Genesis & Mini Genesis Playlist
V6CF Playlist
3Key Playlist
RTC1000 Playlist
Full Power Test
Please note, a full power test is not an appropriate action for every error code.
- The full power test is used to check the relays and elements of the kiln. Program a 1-segment Ramp-Hold program to go up as fast as possible to 1000°F with no hold (1 segment, RA1 9999, oF1 1000, HLd1 0000) or program a Fast Glaze program to cone 04. Leave the lid of the kiln open and start the firing. Visually inspect the elements after the kiln has fired for 10 to 20 minutes. Observe each element from where it comes into the kiln all the way around to see that it is equally bright throughout.
- The following observations are possible:
- One section of the kiln is dark and not going on.
- This indicates a defective relay since there is usually one relay per section.
- One element is not glowing at all.
- This indicates a broken element.
- There are darker (cool) spots along the elements.
- This indicates worn elements.
- The top and bottom elements appear brighter.
- This is normal for many kilns that have hotter elements in the top and bottom.
- After you have made your observations, turn off the kiln.